| –
| Place the separating device-1- between the wheel bearing housing and the wheel hub, and pre-tighten. |
| Location: The straight surfaces of the edges must face the wheel hub |
| –
| Fit the bell-2-, hollow piston cylinder-3- with the pull bolt and special nut-4-. |
| –
| Pull off the wheel hub, securing the device during this operation to prevent it from moving. |
| 3 - | Hollow piston cylinder -HKZ-15- |
| 4 - | Special nut - E-8-214- and pull bolt |
| 5 - | High-pressure hose and quick coupling |
|
|
|
