SEAT Workshop Service and Repair Manuals > Leon Mk2 > Running gear | Running gear, axles, steering | Front suspension, drive shafts | Support strut, stabiliser bar, swinging arms | Removing and installing front left vehicle level senderG78

Removing and installing front left vehicle level senderG78

Removing and installing front left vehicle level sender -G78-

Special tools and workshop equipment required

t	Torque wrench -V.A.G 1410-

Removal:

Note

To remove front left vehicle level sender -G78-, steering must be turned to right lock to ensure clearance between suspension link and anti-roll bar.

–	Remove the electrical connector.

–	Remove bolt and nut.

–	Take out vehicle level sender.

Installation

Installation is carried out in reverse order. In the process, note the following:

Note

t	Lever on vehicle level sender must face towards outside of vehicle.

t	Thread of vehicle level sender must be screwed into front hole in suspension link. Lug of bracket for vehicle level sender must engage in rear hole in order to guarantee correct installation position.

–	Perform basic setting of headlights → "Guided fault-finding" function of vehicle diagnostic, testing and information system VAS 5051

Tightening torques

Component

Tightening torque

Bolt to subframe

9 Nm

Nut

t	Use new nut

9 Nm

SEAT Workshop Service and Repair Manuals