seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Press-in the bracket with the rubber-bonded metal mount > < Replacing the bearing bracket with rubber-bonded metal mount of the control arm

Leon Mk2

Press-out the bracket with the rubber-bonded metal mount
Press-out the bracket with the rubber-bonded metal mount
–  Remove the transversal swinging arm with block support → Chapter.
l  The bonded rubber bearing is only supplied as a spare part with the support bracket.
   
Replace the support bracket with the bonded rubber bearing
l  Release the transversal swinging arm from the support bracket.
–  Place the support tool -T20169- below the clutch pedal bracket without holding the transversal swinging arm.
–  Position the counterhold -U-20003- above the transversal swinging arm rod.
–  Release the support bracket with bonded rubber bearing from the transversal swinging arm.
  E42-10006

Press-in the bracket with the rubber-bonded metal mount > < Replacing the bearing bracket with rubber-bonded metal mount of the control arm