Leon Mk2
1 - | Outer constant velocity joint |
q | Always replace completely |
q | Removing → Fig. |
q | Installing: insert into the propeller shaft up to the stop by hitting with a plastic hammer |
q | check → Chapter |
2 - | Bolt. |
q | Different versions available |
q | Assignment → Electronic parts catalogue „ETKA“ |
q | M16 x 1.5 x 80 |
q | Hexagon bolt = 180 Nm + 180° further |
q | Loosening and tightening hexagon bolt for drive shaft → Chapter |
WARNING
|
3 - | Drive shaft |
q | Allocation: → Parts catalogue |
4 - | Clamp |
q | Replace after each removal |
q | Tension → Fig. |
5 - | Dust boot |
q | Ensure that there is no damage or cracks from friction |
6 - | Clamp |
q | Replace after each removal |
q | Tension → Fig. |
7 - | Dished spring |
q | Installation position → Fig. |
8 - | Thrust washer |
q | Installation position → Fig. |
9 - | Circlip |
q | Replace after each removal |
q | Fit into the groove on the complete half-shaft |
10 - | Dustguard for constant velocity joint |
q | Without breather hole |
q | Ensure that there is no damage or cracks from friction |
q | Separate from the constant velocity joint using an awl |
q | Apply grease → Parts catalogue to the sealing surface before connecting the dustguard to the constant velocity joint |
11 - | Clamp |
q | Replace after each removal |
q | Tension → Fig. |
12 - | Locking plate |
13 - | Bolt. |
q | 20 Nm + 90° |
q | Always replace bolts after dismounting |
14 - | Circlip |
q | Replace after each removal |
q | Insert and remove using pliers -VW 161 A- |
15 - | Seal |
q | Replace after each removal |
q | The surface that is attached to the constant velocity joint should be free of grease and oil |
16 - | Inner constant velocity joint |
q | Always replace completely |
q | Pressing off → Fig. |
q | Pressing on → Fig. |
q | check → Chapter |
17 - | Dished spring |
q | With internal groove |
q | Installation position → Fig. |
|