Leon Mk2
| Steering knuckle and trailing arm (all-wheel drive) - Assembly overview |
| -Arrow- points in direction of normal travel. |
| 1 - | Cover |
| 2 - | Mounting bracket |
| 3 - | Coupling rod |
| q | Connects anti-roll bar to trailing arm/wheel bearing housing |
| 4 - | Bolt. |
| q | 90 Nm and then turn 45° further |
| q | Observe tightening sequence → Fig.. |
| q | Always renew if removed |
| 5 - | Trailing arm |
| q | removing and installing → Chapter |
| q | Repairs → Chapter |
| 6 - | Drive shaft |
| q | Assembly overview → Chapter |
| q | removing and installing → Chapter |
| 7 - | Multi-point socket head bolt |
| q | M14 x 1.5 x 45 |
| q | 70 Nm and then turn 90° further |
| q | Always renew if removed |
| 8 - | Wheel bearing housing |
| q | removing and installing → Chapter |
| 9 - | Rear right speed sensor -G44-/rear left speed sensor -G46- |
| q | Can be tested in guided fault finding using → Vehicle diagnostic tester |
| q | Before inserting sensor, clean inner surface of bore and coat with lubricating paste -G 000 650- |
| 10 - | Hexagon socket head bolt |
| q | M6 x 16 |
| q | 8 Nm |
| 11 - | Bonded rubber bush |
| q | replace → Chapter |
| 12 - | Nut |
| q | M12 x 25 |
| q | 40 Nm |
| q | Self-locking |
| q | Always renew if removed |
| 13 - | Brake disc |
| 14 - | Bolt. |
| q | 4 Nm |
| 15 - | Bolt. |
| q | 200 Nm and then turn 180° further |
| q | Assignment → Electronic parts catalogue „ETKA“ |
| q | Always renew if removed |
| 16 - | Wheel hub with wheel bearing |
| q | The ABS sensor ring is installed in the wheel bearing |
| q | removing and installing → Chapter |
| The wheel bearing and wheel hub are assembled in one housing. |
| This wheel bearing is maintenance-free and has zero play. Carrying out adjustment and repair work is therefore not possible! |
| 17 - | Bolt. |
| q | M6 x 12 |
| q | 12 Nm |
| 18 - | Cover plate |
| 19 - | Bolt. |
| q | M12 x 1.5 x 80 |
| q | 90 Nm and then turn 90° further |
| q | Always renew if removed |
| 20 - | Bonded rubber bush |
| q | replace → Chapter |
| 21 - | Bolt. |
| q | M10 x 35 |
| q | 50 Nm and then turn 45° further |
| q | Always renew if removed |
