SEAT Workshop Service and Repair Manuals > Leon Mk2 > Running gear | Running gear, axles, steering | Rear suspension, drive shaft | Subframe, final drive (all-wheel drive) - Assembly overview

Fixing position of subframe

Special tools and workshop equipment required

t	Locking device -T10096-

t	Engine/gearbox jack -V.A.G 1383 A-

Carry out the following work:

Installing locating pins -T10096-

–	Position engine and gearbox jack -V.A.G 1383 A- underneath subframe and secure with tensioning strap.

To fix position of subframe, locating pins -T10096- must be screwed in successively at positions -1- and -2- on both sides of vehicle.

–	Unscrew one hexagon bolt -1- or -2- on both sides.

Note

Only the left side of vehicle is shown to improve clarity.

–	Secure position of subframe with locating pins -T10096-.

Note

The locating pins -T10096- must not be tightened to more than 20 Nm, otherwise the threads of the locating pins will be damaged.

–	Replace securing bolts on subframe with locating pins -T10096- one after the other on both sides of the vehicle and tighten to 20 Nm.

The position of the subframe is now fixed.

SEAT Workshop Service and Repair Manuals