Leon Mk2
| Power steering hydraulic pump: removing and fitting |
Note| t | Replace the join rings. |
| t | Never re-use the hydraulic oil. |
| t | Filling quantities and oil type → Chapter. |
| 1 - | Securing bolt |
| q | 25 Nm |
| q | Before loosening, remove the Poly-V belt → Chapter |
| 2 - | Pulley |
| 3 - | Poly V-belt |
| q | Before removing it, mark the direction of rotation. |
| q | Removing and installing → Chapter |
| q | Check condition → Booklet |
| 4 - | 25 Nm |
| 5 - | Hollow bolt |
| q | 30 Nm |
| 6 - | Join ring |
| q | Always replace |
| 7 - | Pressure tubing |
| 8 - | Hydraulic pump |
| q | To verify feed pressure → Chapter |
| q | Before fitting, fill with oil → Chapter |
| 9 - | Flexible tube clip |
| 10 - | Suction line |
| q | Following fitting, ensure that the suction pipe is not bent. |
| q | The colour mark coincides, depending on the version, with the separation edge of the case or the mark on the pump tube. |
| 11 - | 45 Nm |
Note| First tighten the bolt → Item, then the bolt → Item, then the bolt → Item and → Item. |
| 12 - | 45 Nm |
Note| First tighten the bolt → Item, then the bolt → Item, then the bolt → Item and → Item. |
| 13 - | 45 Nm |
Note| First tighten the bolt → Item, then the bolt → Item, then the bolt → Item and → Item. |
| 14 - | 45 Nm |
Note| First tighten the bolt → Item, then the bolt → Item, then the bolt → Item and → Item. |
