SEAT Workshop Service and Repair Manuals > Leon Mk2 > Vehicle electrics | Electrical system | Lights, lamps, switches outside | Steering column of the switch module, Vehicles ? 05/2010 | Lever switch for windscreen wiper/washer, indicators/light switching, Cruise control: removing and fitting

Lever switch for windscreen wiper/washer, indicators/light switching, Cruise control: removing and fitting

Caution

The removal and assembly of specific components belonging to the steering column combined control must be carried out in a specific order. → Chapter

Note

t	The „indicator switch“ consists of the components indicator switch -E2-, the dipped light beam switch and the flasher light -E4- and, depending on the equipment, thecruise control switch -E45- or CCS.

t	For purposes of clarity, the following figure shows the combined switch with CCS switch -E45- removed.

Removing:

–	Disconnect the battery.

–	Remove driver's side airbag module → Bodywork, Interior fitting work; Rep. gr.69

–	Remove steering wheel → Chassis, axles, steering; Rep. gr.48.

–	Remove the steering column trim → Bodywork, interior installation work; Rep. gr.68.

–	Remove steering column electronics control unit -J527-.

–	Remove the airbag spiral spring/retractor ring with collector ring -F138-.

–	Remove steering angle sender -G85- → Chapter:

Note

The following operations are shown with the steering column switch module removed, for better clarity of representation.

–	Remove retaining clips with a thickness gauge of 1.0 mm - Item 1--arrows- and remove left lever switch.

–	Remove retaining clips with a thickness gauge of 1.0 mm - Item 1--arrows- and remove right lever switch.

SEAT Workshop Service and Repair Manuals