| –
| Place a flat spanner (e/c 25) -1- in the setting tool -U-40081- and adjust the windscreen wiper arm -2- to the setting specified in the table. |
| –
| Loosen securing bolt -3- and remove the windscreen wiper arm -2- from the setting tool -U-40081-. |
| –
| Remount the windscreen wiper arm -2- in setting tool -U-40081- and fix it with the securing bolt -3-. |
| –
| Compare the angle measured with the specification from the table. |
| –
| When necessary, repeat the adjusting process until the specification is obtained. |
| –
| Remove setting tool -U-40081- and fit the brushes. |
|
|
|
