seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Renewing headlight bulbs > < Halogen headlamps: Removing and installing

Leon Mk2

Correct the headlamp installation position
Correct the headlamp installation position
Special tools and workshop equipment required
   
t  Torque wrench -V.A.G 1331-
  Note
t  Gap and flush fit of the headlight when installing (wing, bumper and bonnet) → Rep. gr.00
t  The fixing support for the headlamp must be flush.
  W00-0427
–  Loosen bolts -2-, -3- and -6-.
–  Adjust the height and inclination of the headlights using the hexagon nuts → Rep. gr.00.
–  Tighten the bolts -2-, -3- and -6- in this sequence in order to bring the headlight flush with the bodywork → Rep. gr.00.
  Note
The adjustment must be carried out following each removal and installation or after correcting the installation position in all cases → Chapter.
  E94-10448

Renewing headlight bulbs > < Halogen headlamps: Removing and installing