skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing door window > < Door adjustment

Fabia Mk1

Removing and installing assembly carrier
Removing and installing assembly carrier
  Note
The assembly carrier is removed together with the door lock and window lifter.
Removing
–  Remove front door trim panel → Chapter.
–  Removing the lock cylinder housing → Chapter.
   
–  Release caps of holes -1-.
–  Lower the door window until the fixing screws -2- of the door window can be reached.
–  Release fixing screws.
  Note
If this operation cannot be performed due to a failure at the power-window lifter, unscrew the power-window motor and then push the window down.
–  Push door window upwards and secure (e.g. with adhesive tape).
–  Separate the electrical plug connections.
–  Release the cable harness from the assembly carrier and pull out the cable ducts.
–  On vehicles with convenience system disconnect the plug connection from the complete door lock.
For vehicles ? 11.03
  S57-0085
–  Release screws -arrows-. Release the assembly carrier from the door, raise and remove the door towards the hinge side from the door.
For vehicles 12.03 ?
–  Bore out rivet heads -arrows-. Release the assembly carrier from the door, raise and remove the door towards the hinge side from the door.
  Note
t  After drilling open the rivets of the assembly carrier carefully remove the remaining rivets inside the doors, in order to avoid corrosion and noises.
t  Carry out protection against corrosion on both damaged points.
Install
–  Position the assembly carrier in the door.
–  Attach wiring loom to assembly carrier and plug in all the plug connections.
For vehicles ? 11.03
  S57-0087
–  Insert all screws. First tighten screws -1- and -2- → Anchor.
–  The remaining screws may be tightened in random sequence.
For vehicles 12.03 ?
–  Install assembly carrier on the centering pin in the area of the holes -1- and -2-.
–  First of all rivet the assembly carrier on the centering pin -1- and -2- and then in random sequence.
  Note
When installing the assembly carrier use original replacement parts only (tear-off rivets).
For all vehicles
–  Installing the lock cylinder housing → Chapter.
–  Lower the door window until screws -4- are located behind holes -5-.
–  Push door window -3- in the window run -arrow- and tighten the clamping jaws with screws -4-.
Further installation occurs in reverse order.
  S57-0092
Tightening torques
ComponentTightening torques
Assembly carrier to door8 Nm, observe screw sequence
Screws for clamping jaws (door window in window version)10 Nm

   

Removing and installing door window > < Door adjustment