Removing and installing the locking button for locking rod |
Note t
| The locking knob must be removed and installed as described below. |
t
| Failing to comply with these instructions may cause the locking rod to loosen or the support may become damaged. |
–
| Turn the locking button 180° to the left. |
–
| Remove the locking button from the top. |
–
| Position the locking button with the marking (dot on top side) on the locking rod. |
–
| Press the locking button down onto the locking rod until the spline is at the level of the door trim panel. |
–
| Subsequently, turn the locking button 180° to the left. |
Note The locking button may project about 0 to 2 mm above door trim panel in the locked position. |
|
|
|