Removing and installing the front entrance plates |
1 - | Connection of interior trim |
Special tools and workshop equipment required |
t
| Hot air pistol (e.g. -V.A.G 1416-) |
t
| Cleaning solution (e.g. -D 009 401 04-) |
–
| Heat entrance plate to around 100 °C with hot air pistol. |
–
| Separate entrance plate from door bottom. |
–
| Clean the contact surface of the door bottom with cleaning solution -D 009 401 04-. |
–
| Remove protective films from adhesive tapes. |
–
| Position the front edge of the plate to the connection -1- of the interior trim (tolerance ± 2 mm) and stick the entrance plate onto the door bottom. |
|
|
|