Skoda Workshop Service and Repair Manuals

Removing and installing the glass roof Removing –  Slide sun screen backwards. –  Tilt sliding/tilting roof.

–  Unclip guard bottom -1- and pull forwards away from the roof frame. –  Unclip top trim strip -2- at front and middle and unhook at rear.

–  Release screws -1-. –  Remove glass roof from the top. Install Glass roof must be fitted in the “0” position → Chapter.

–  The sliding-block guide bolt axis must be flush with the marking on the sliding-block guide -arrow-. –  If the “sliding-block guide axis” is not flush with the sliding-block guide then parallel running must be adjusted for → Chapter.

–  Insert glass panel for sliding/tilting roof from the top and slightly tighten the fixing screws -1-.   Note Adjust the pane height before tightening up the fixing screws. –  Setting the glass roof height → Chapter.

–  Tighten glass roof screws -1-. Tightening torque - 4.5 Nm.

–  Hook on top trim strip -2- at rear and middle and clip on at front. –  Slide the bottom trim strip -1- towards -direction of arrow- the rear and hook on in front area.