Code control unit - ABS BOSCH 5.7 |
Special tools and workshop equipment required |
t
| Vehicle system tester -V.A.G 1552- or vehicle diagnosis, measurement and information system -VAS 5051- |
t
| Diagnostic cable -V.A.G 1551/3, 3A, 3B, 3C-, -VAS 5051/5A- or -VAS 5051/6A- |
The control unit built into the vehicle is coded. New control units supplied through the spares warehouse are not coded and must be coded after being installed. |
Perform coding with the vehicle diagnosis, measurement and information system -VAS 5051-. |
Perform coding with the vehicle system tester -V.A.G 1552- |
Coding is only possible if the workshop code (WSC) has been entered into the vehicle system tester -V.A.G 1552- and when function 11 „Coding 2“ was also successfully performed on vehicles with ABS/EDL/TCS/ESP. |
–
| Determine the engine identification characters and the type of ABS hydraulic control unit fitted on the vehicle. |
–
| Connect up vehicle system tester -V.A.G 1552- and enter the control unit for brake electronics with the ignition switched on (address word 03) → Chapter. |
|
|
|