skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Table of codes > < Table of codes

Fabia Mk1

Code control unit - ABS BOSCH 8.0
Code control unit - ABS BOSCH 8.0
Special tools and workshop equipment required
t  Vehicle system tester -V.A.G 1552- or vehicle diagnosis, measurement and information system -VAS 505x-
The control unit built into the vehicle is coded. New control units supplied through the spares warehouse are not coded and must be coded after being installed.
Perform coding with the vehicle diagnosis, measurement and information system -VAS 505x- → Vehicle diagnostic, testing and information system VAS 5051
Perform coding with the vehicle system tester -V.A.G 1552-
Coding requirements
Coding is only then possible if the workshop code (WSC) has been entered into the vehicle system tester -V.A.G 1552- and when function 16 „access authorisation“ was also successfully performed.
Test sequence
–  Determine the engine identification characters and the type of ABS hydraulic control unit fitted on the vehicle.
–  Connect up vehicle system tester -V.A.G 1552- and with the ignition switched on enter → Chapter the address word 03 - brake electronics
   
Readout on display:
–  Select function 07„Coding control unit“ and confirm with Q.
  
Vehicle system test               HELP
Select function XX
Readout on display:
–  Enter the relevant code number of the vehicle and confirm with Q.
Table of codes → Chapter
  
Coding control unit
Enter code number  XXXXXXX

Table of codes > < Table of codes