Fabia Mk1
| Summary of components - Electrical/electronic components and fitting locations of ABS/ESP systems BOSCH 8.0 |
| All components marked with 1) can be tested using the vehicle system tester -V.A.G 1552- or the fault read-out scan tool -V.A.G 1551- or using the vehicle diagnosis, measurement and information system -VAS 5051-. |
| 1 - | Hydraulic control unit BOSCH 8.0 1) |
| q | fitted as of CW 22/2004 |
| q | different versions: |
| t | ABS |
| t | ABS/TCS |
| t | Assignment → Electronic Catalogue of Original Parts |
| t | Distinguishing features → Chapter |
| q | Fitting position: in right of engine compartment |
| q | removing and installing → Chapter |
| 2 - | Traction control system switch -E132 - or TCS and ESP button -E256-1) |
| q | Fitting location: centre part of dash panel above radio |
| q | Operation: Switching off the TCS or ESP function |
| q | removing and installing → Electrical System → Rep. gr.96 |
| 3 - | Traction control system warning light -K86- or ESP and TCS warning light -K155- |
| q | Fitting location: in dash panel insert - Pos. 6 |
| Operation: |
| q | The warning light lights up: |
| t | for about 2 seconds after ignition is switched on |
| t | if fault is detected in TCS or ESP operation |
| t | after switching the traction control system switch or TCS and ESP button to „OFF“ |
| → Chapter |
| q | The warning light flashes: |
| t | during TCS/ESP control |
| 4 - | ABS warning light -K47- |
| q | Fitting location: in dash panel insert - Pos. 6 |
| Operation: |
| q | The ABS warning light lights up: |
| t | for about 2 seconds after the ignition is switched on or the engine is started |
| t | if a fault is detected, e.g. open circuit to wheel speed sensor |
| → Chapter |
| 5 - | Dual circuit and hand brake system warning light -K7- |
| q | Fitting location: in dash panel insert - Pos. 6 |
| Operation: |
| q | Dual circuit and hand brake system warning light: |
| t | lights up if hand-brake is applied |
| t | flashes if low brake fluid level |
| t | lights up for about 2 seconds after ignition is switched on |
| t | lights up if the electronic brake pressure distribution fails, i.e. when the ABS warning light -K47- comes on |
| 6 - | Dash panel insert |
| q | fitted up to model year 2004 |
| 7 - | Traction control system warning light -K86- or ESP and TCS warning light -K155- |
| q | Fitting location: in dash panel insert - Pos. 10 |
| Operation: |
| q | The warning light lights up: |
| t | for about 2 seconds after ignition is switched on |
| t | if fault is detected in TCS or ESP operation |
| t | after switching the traction control system switch or TCS and ESP button to „OFF“ |
| → Chapter |
| q | The warning light flashes: |
| t | during TCS/ESP control |
| 8 - | ABS warning light -K47- |
| q | Fitting location: in dash panel insert - Pos. 10 |
| Operation: |
| q | The ABS warning light lights up: |
| t | for about 2 seconds after the ignition is switched on or the engine is started |
| t | if a fault is detected, e.g. open circuit to wheel speed sensor |
| → Chapter |
| 9 - | Dual circuit and hand brake system warning light -K7- |
| q | Fitting location: in dash panel insert - Pos. 10 |
| Operation: |
| q | Dual circuit and hand brake system warning light: |
| t | lights up if hand-brake is applied |
| t | flashes if low brake fluid level |
| t | lights up for about 2 seconds after ignition is switched on |
| t | lights up if the electronic brake pressure distribution fails, i.e. when the ABS warning light -K47- comes on |
| → Chapter |
| 10 - | Dash panel insert |
| q | fitted as of model year 2005 |
| 11 - | Steering angle sender -G85-1) |
| q | only on vehicles with ABS/TCS/ESP BOSCH 8.0 |
| q | Fitting location: on the steering column between the steering wheel and the steering column switch |
| q | removing and installing → Chapter |
| 12 - | Diagnostic connection |
| q | Fitting location: in the storage compartment on the driver's side |
| 13 - | Rear right and rear left wheel speed sensors -G44/G46-1) |
| q | removing and installing (disc brake or drum brake) → Chapter |
| q | Rear wheel speed sensor cables |
| t | removing and installing (disc brake or drum brake) → Chapter |
| 14 - | Wheel hub with wheel bearing |
| q | Sensor ring for ABS is built into the wheel hub |
| t | removing and installing: can only be replaced together with wheel hub and wheel bearing → Chapter |
| 15 - | Handbrake warning switch -F9-1) |
| q | Fitting location: on handbrake lever |
| q | removing and installing → Chapter |
| 16 - | ESP sensor unit -G419-1) |
| q | only on vehicles with ABS/TCS/ESP BOSCH 8.0 |
| q | Fitting location: under the left front seat |
| q | removing and installing → Chapter |
| q | Lateral acceleration sender -G200- and yaw rate sender -G202- are combined in a common housing with the ESP sensor unit -G419- |
| t | there are no separate fault codes |
| 17 - | Brake light switch -F-1) |
| q | Assignment → Electronic Catalogue of Original Parts |
| q | is open in the off position |
| t | adjust → Chapter |
| t | removing and installing → Chapter |
| t | replace after each removal |
| 18 - | Wheel hub with wheel bearing |
| q | Sensor ring for ABS is built into the wheel hub |
| t | removing and installing: can only be replaced together with wheel hub and wheel bearing → Chapter |
| 19 - | Brake servo unit with master brake cylinder and brake fluid reservoir |
| 20 - | Front right and front left wheel speed sensors -G45/G47-1) |
| q | removing and installing → Chapter |
| q | Front wheel speed sensor cables |
| t | removing and installing → Chapter |
| 21 - | Hydraulic control unit BOSCH 8.0 1) |
| q | fitted as of CW 22/2004 |
| q | ABS/TCS/ESP |
| q | Assignment → Electronic Catalogue of Original Parts |
| q | Distinguishing features → Chapter |
| q | Fitting position: in right of engine compartment |
| q | removing and installing → Chapter |
| q | ABS/TCS/ESP BOSCH 8.0 must not be disassembled and repaired |