Bleeding the brake system of air without using the brake filling and bleeding device |
Special tools and workshop equipment required |
t
| Vehicle system tester -V.A.G 1552- or vehicle diagnosis, measurement and information system -VAS 505x- |
t
| Bleeding bottle (commercially available) |
Note t
| Bleeding the brake system on vehicles with ABS is undertaken in the same way as for vehicles without ABS. |
t
| On vehicles without ABS and with load-dependent brake-power regulator, move the lever of the brake-power regulator while bleeding the rear wheel-brake. |
t
| While bleeding continuously check the brake fluid level in the brake fluid reservoir and top up brake fluid if necessary up to the „MAX“ marking. |
–
| Build up pressure in the brake system by pumping the brake pedal. |
–
| Open the vent valve with the hose of the bleeding bottle fitted. |
–
| Close the vent valve while the pedal is pressed down. |
–
| Repeat this procedure until no more air escapes. |
1.
| Rear right wheel-brake cylinder/brake caliper |
2.
| Rear left wheel-brake cylinder/brake caliper |
3.
| Front right brake caliper |
4.
| Front left brake caliper |
–
| After bleeding close the relevant vent valve and fit dust cap. |
Note After bleeding perform a test drive. While doing so perform at least one ABS adjustment! |
–
| Perform test drive with ABS adjustment. |
Vehicles with ABS/EDL/TCS or ABS/EDL/TCS/ESP BOSCH 5.7 |
Note The bleeding of the brake system on vehicles with ABS/EDL/TCS or ABS/EDL/TCS/ESP BOSCH 5.7 occurs via the basic setting. |
t
| with the vehicle system tester -V.A.G 1552- → Chapter |
–
| Perform test drive with at least one ABS adjustment. |
Vehicles with ABS//TCS/ESP BOSCH 8.0 |
Note The bleeding of the brake system on vehicles with ABS/TCS/ESP BOSCH 8.0 occurs via the basic setting. |
t
| with the vehicle system tester -V.A.G 1552- → Chapter |
–
| Perform test drive with at least one ABS adjustment. |
|
|
|