skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Checking the feed pressure of the engine pump aggregate > < Inspecting engine pump aggregate
Inspecting the operation of the engine pump aggregate
Inspecting the operation of the engine pump aggregate
Special tools and workshop equipment required
t  Vehicle diagnosis, measurement and information system -VAS 505x-
The checking of the function is identical for the engine pump aggregates of TRW and KOYO.
Functional test
–  Raise vehicle.
–  Remove front left wheel.
–  Remove the front left wheelhouse liner → Body Work; Rep. gr.66.
–  Switch on ignition.
–  Start engine.
–  If necessary turn steering up to stop.
–  Listen to and/or touch the engine pump aggregate to check whether it is running.
If the engine pump aggregate is not working:
–  Perform self-diagnosis of the power-steering → Chapter.
–  Switch off ignition.
–  Remove fault.
–  Install the front left wheelhouse liner → Body Work; Rep. gr.66.
–  Install left front wheel.
–  Lower the vehicle.
If the engine pump aggregate is working and if there are other faults:
–  Perform self-diagnosis of the power-steering → Chapter.
If faults are stored in the fault memory:
–  Remove fault.
–  Erase fault memory.
If a fault is stored in the fault memory:
–  Check the feed pressure of the engine pump aggregate → Chapter.
   
Tightening torque:
Wheel bolts120 Nm

   

Checking the feed pressure of the engine pump aggregate > < Inspecting engine pump aggregate