skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Checking wires > < Check for proper operation

Fabia Mk1

Testing the power supply of the Accelerator pedal position sender
Testing the power supply of the Accelerator pedal position sender
–  Remove the bottom part of the dash panel on the driver's side → Body Work → Rep. Gr.70.
–  Disconnect the plug connection of the accelerator pedal position sender.
–  Switch on ignition.
   
–  Connect handheld multimeter for voltage measurement as follows:
  S20-0192
6-pin plug on wiring loom, contactSpecified value 
1 + earthapprox. 5 V 
1 + 5approx. 5 V
2 + earthapprox. 5 V
2 + 3approx. 5 V

If the specified values are reached:
–  Also test the wiring from the engine control unit to the accelerator pedal position senders → Chapter.
If the specified values are not reached:
–  Test the wiring from the engine control unit to the accelerator pedal position senders → Chapter.
   

Checking wires > < Check for proper operation