Skoda Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Testing the intake system for tightness (unmetered air) >
< Test control
Fabia Mk1
Drive unit
1.4/55; 1.4/59; 1.4/74 engine - fuel injection
Mixture preparation system, electronic inj.,Gas
Testing components and functions / sting__exhaust_gas_recirculation_valve_n18/">Testing Exhaust gas recirculation valve N18
Checking voltage supply
Checking voltage supply
Checking voltage supply
Test conditions
l
Fuse no. 7 o.k.
Test sequence
–
Disconnect the 6-pin plug on the exhaust gas recirculation valve -N18-
-arrow-
.
–
Connect the diode test lamp between contact 1 of the plug and the engine mass.
–
Activate the starter.
The diode test lamp must light up.
If the diode test lamp lights up and no fault was detected in the wiring:
–
Replace engine control unit
→ Chapter
.
If the diode test lamp does not light up:
–
Check the cable between the fuse No. 7 and the ignition starter switch for interruption according to the current flow diagram
→ Current flow diagrams and Fitting locations
.
Drive unit
1.4/55; 1.4/59; 1.4/74 engine - fuel injection
Mixture preparation system, electronic inj.,Gas
Testing components and functions / sting__exhaust_gas_recirculation_valve_n18/">Testing Exhaust gas recirculation valve N18
Checking voltage supply
Testing the intake system for tightness (unmetered air) >
< Test control