skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the unit injector > < Summary of components

Fabia Mk1

Removing and installing O-rings for unit injector
   
Removing and installing O-rings for unit injector
Special tools and workshop equipment required
t  Assembling sleeves -T10056-
Removing
–  Lever off the old O-rings from the unit injector with extreme care.
–  Make sure, above all, that no gradient occurs at the base of the O-rings.
Install
  Note
t  Always use the assembly sleeves to install the O-rings. Otherwise there is the danger of damaging the O-rings.
t  Avoid rolling the O-rings when sliding them on. The O-rings must not be turned inwards on the seat of the unit injector.
–  Remove the heat-protection seal along with the circlip.
–  Clean the seating surfaces for the O-rings in the unit injector with great care.
  W00-0989
–  Insert the assembling sleeve - T10056/1- on the unit injector up to the stop.
–  Carefully slide the top O-ring onto the assembling sleeve and into the groove of the unit injector.
–  Remove assembly sleeve.
  N23-0313
–  Insert the assembling sleeve - T10056/2- on the unit injector up to the stop.
–  Carefully slide the middle O-ring onto the assembling sleeve and in the groove of the unit injector.
–  Remove assembly sleeve.
  N23-0314
–  Insert the assembling sleeve - T10056/3- on the unit injector up to the stop.
–  Carefully slide the lower O-ring onto the assembling sleeve and in the groove of the unit injector.
–  Remove assembly sleeve.
–  Slide on a new heat-protection seal together with the circlip.
  N23-0315

Removing and installing the unit injector > < Summary of components