–
| Slowly press the accelerator pedal and observe display fields 2 and 3. |
t
| Display field 2: The value of the accelerator pedal position must increase gradually. |
| Nominal value at full throttle position: 100.0 % |
t
| Display field 3: The value must become 0 0 0. |
–
| Select function 06 “End output” and confirm with Q. |
If the final nominal value is not reached: |
If the display does not change or changes irregularly: |
Test the wires of the accelerator pedal position sender as follows: |
–
| Connect test box -V.A.G 1598/31 - to the wiring loom on the engine control unit . |
–
| Disconnect the connector from the accelerator pedal position sender -G79-. |
|
|
Reading measured value block 2 -> | 0/min 100.0 % 0 0 0 18.4 °C |
|