Fabia Mk1
Summary of components |
Note
Connection elements of the air conditioning unit → Fig. |
1 - | Wiring loom of air conditioning unit |
q | carefully cut open to remove cable strap |
q | when installing new cable strap fit in same location |
2 - | Top part evaporator housing |
q | Top part - bottom part connection with screws and retaining clips → Fig. |
3 - | Support |
q | Screwed connection on module carrier and on heater unit |
q | module carrier tightening torque: 12 Nm |
q | Tightening torque of the air conditioning unit: 5 Nm |
4 - | Fresh air blower series resistor -N24- |
q | removing and installing → Chapter |
5 - | Foam seal |
q | replace if damaged |
q | self-adhesive |
q | stuck onto evaporator housing |
q | before fitting remove glue residues on housing with acetone |
6 - | Expansion valve |
q | Summary of components → Chapter |
7 - | Air inlet housing |
q | with fresh and re-circulating air flap |
q | Fitted to housing top and bottom part with retaining clips → Fig. |
8 - | Sealing ring |
q | replace if damaged |
q | self-adhesive |
q | before fitting remove glue residues on housing with acetone |
9 - | Dust and pollen filter |
q | also as combination filter with odour filter |
10 - | Fresh air flap and re-circulating air flap control motor -V154- |
q | clipped into holder → Chapter |
q | removing and installing → Item |
11 - | Support |
q | for fresh air flap and re-circulating air flap control motor -V154- → Item |
12 - | Fresh air blower -V2- |
q | removing and installing → Chapter |
13 - | Holder for fresh air blower -V2- |
q | Disconnecting fresh air blower from holder ⇒ Removing and installing fresh air blower → Chapter |
14 - | Evaporator housing - bottom part |
q | Top part - bottom part connection with screws and retaining clips → Fig. |
15 - | Filter cover |
16 - | Bottom part of distributor housing |
17 - | Heating element for additional air heating (PTC) -Z35- |
q | removing and installing → Chapter |
18 - | Heat exchanger |
q | removing and installing → Chapter |
19 - | Positioning unit for air distribution flaps |
q | removing and installing → Chapter |
20 - | Seal for evaporator |
q | Observe installation position: Water drain openings must point downwards |
21 - | Evaporator |
q | removing and installing → Chapter |
22 - | Top part of distributor housing |
q | on evaporator housing top part and bottom part |
23 - | Support, left |
q | Screwed connection to module carrier, air conditioning unit and centre console support |
q | module carrier tightening torque: 12 Nm |
q | Tightening torque of the air conditioning unit: 5 Nm |
q | Centre console support tightening torque: 12 Nm |
24 - | Support |
q | for temperature flap control motor -V68- |
25 - | Control motor for temperature flap -V68- |
q | removing and installing → Chapter |