skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and fitting the heating and air conditioning system control > < Removing

Fabia Mk1

Install
Install
Installation is performed in the reverse order, pay attention to the following points:
–  Moisten sealing lips of the gasket in the bulkhead (assembly plate) with a neutral soapy solution before installing the air conditioning unit (easier mounting).
   To this end fold up the cover of the heat-protection matting before the valve for consendation water drain.
   
–  Fold up cover -1-.
–  Press the sealing lip -3- of the gasket -6- all around the slot of the support -2- for the valve for condensation water drain -7--arrows-.
–  Press the sealing lip -4- of the gasket -6- all around the slot of the support -arrows- of the heat exchanger -5-.
  Note
When closed the cover -1- must be flush with the heat-protection matting. If the cover -1- is pressed too far inwards, the cap of the valve for condensation water drain -7- may become stuck.
  S87-0129
–  Press the sealing lip of the gasket -1- all around the slot of the evaporator housing -2--arrows-.
–  Remove the cover for the bore holes of the expansion valve.
–  Replace O-rings of connection fitting of heat exchanger and expansion valve.
–  Connect coolant hoses the right way round.
   In direction of travel
on the left: Feed
on the right: Return flow
–  Inspect coolant level, top up with coolant if necessary.
  Note
If the heat exchanger was replaced, fill system with fresh coolant.
–  Replacing dessicator insert → Chapter.
–  Fill the refrigerant circuit with the aid of the A/C service station.
  S87-0164

Removing and fitting the heating and air conditioning system control > < Removing