skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing flex shafts > < Removing and installing heater control

Fabia Mk1

Removing and installing dust pollen filter
Removing and installing dust pollen filter
Removing
  Note
t  It is possible to remove and install the filter without taking off any trim panel.
t  A combination filter also exists. This has an integrated odour filter. The removal and installation procedure is similar.
t  The filter insert and frame together constitute a replacement part.
   
–  Push slides -1- fully in -arrows-.
–  Take filter cover -3- down and off.
–  Pull dust and pollen filter -2- down and out by the tab.
Install
Installation is carried out in the reverse order. Pay attention to the following:
t  Before installing check the fitting position of the filter insert. The top and bottom fin of the filter insert must be in the frame.
t  The 2 arrows on the frame and filter insert point to the flow direction.
t  The frame grid must point to the distributor housing.
t  The filter cover -3- must be correctly positioned in the housing and the slides -1- must be pushed fully outwards up to the stop.
  S80-0097

Removing and installing flex shafts > < Removing and installing heater control