Skoda Workshop Service and Repair Manuals > Fabia Mk1 > Heating, Air conditioning | Heating, Air conditioning | Heating | Removing and installing parts of the heater unit - Part 2 | Removing and installing the control unit for temperature flap

Removing and installing the control unit for temperature flap

Removing

–	Remove storage compartment on driver and passenger side → Body Work; Rep. Gr.70.

–	Removing the dash panel centre part → Body work; Rep. Gr.70.

–	Remove left footwell vent.

–	Remove flex shaft -3- from the control unit -1- → Chapter.

–	Release catch -2- by pressing in the direction of the arrow -A-.

–	Swivel out control unit -1- in the direction of the arrow -B- and remove from brackets -4-.

Install

Note

t	Before installing check whether the position of the worm wheel -1- and the gear segment -2- correspond.

t	The higher turn (darker) -arrow A- must engage in the deeper gear openings -arrow B-.

–	Mark the positions -2- and -4- of the lever for the temperature flap -3- in the end positions (flap fully open/flap fully closed) on the housing.

–	Switch control unit -1- to position “flap closed”.

–	Close temperature flap.

Position lever -3- down to stop.

–	Insert the control unit -1- in the brackets -6- and guide into the housing in the direction of the arrow.

Control unit bolt -1- must engage in the slide -3-.

–	press the control unit into the catch -5-.

–	Insert flex shaft into the control unit -1- → Chapter.

–	Check operation of the control unit.

It must be possible to adjust the temperature flap to its end position in a smooth and easy way (markings -2- and -4-).

If the temperature flap adjustment is not O.K.:

–	Remove control unit again and install - as described above.

If the temperature flap adjustment is O.K.:

–	Install left footwell vent.

–	Installing the dash panel centre part → Body Work; Rep. Gr.70.

–	Install storage compartment on driver and passenger side → Body Work; Rep. Gr.70.

Skoda Workshop Service and Repair Manuals