Fabia Mk1
Disassembling and assembling the heater unit |
Note
Connection elements of the heater unit → Fig. |
1 - | Heater unit wiring loom |
q | carefully cut open to remove cable strap |
q | when installing new cable strap fit in same location |
2 - | Housing top and bottom part |
q | Connection with retaining clips → Fig. |
3 - | Support |
q | Screwed connection on module carrier and on heater unit |
q | module carrier tightening torque: 12 Nm |
q | Tightening torque of the heater unit: 5 Nm |
4 - | Series resistor for fresh air blower with overheating fuse -N24- |
q | removing and installing → Chapter |
5 - | Air inlet housing |
q | with fresh and re-circulating air flap |
q | Fitted to housing top and bottom part with retaining clips → Fig. |
6 - | Gasket |
q | replace if damaged |
q | self-adhesive |
q | before fitting remove glue residues on housing with acetone |
7 - | Fresh/re-circulating air flap control motor -V154- |
q | clipped into holder → Item |
8 - | Support |
q | for fresh/re-circulating air flap control motor -V154- → Item |
9 - | Fresh air blower -V2- |
q | removing and installing → Chapter |
10 - | Holder for fresh air blower -V2- |
q | Disconnecting fresh air blower holder ⇒ Removing and installing fresh air blower |
11 - | Filter cover |
12 - | Dust and pollen filter |
q | also as combination filter with odour filter |
13 - | Positioning unit for air distribution flaps |
q | removing and installing → Chapter |
14 - | Bottom part of distributor housing |
15 - | Heating element for additional air heating (PTC) -Z35- |
q | removing and installing → Chapter |
16 - | Heat exchanger |
q | removing and installing → Chapter |
17 - | Top part of distributor housing |
q | screwed onto the upper and lower part of the heater housing |
18 - | Support, left |
q | screwed connection to module carrier, heater unit and centre console support |
q | module carrier tightening torque: 12 Nm |
q | Tightening torque of the heater unit: 5 Nm |
q | Centre console support tightening torque: 25 Nm |
19 - | Positioning unit for temperature flap |
q | removing and installing → Chapter |