Fabia Mk1
| I - Removing and installing ATF pump up to large sun gear |
| t | Overview → Chapter |
| t | disassembling and assembling → Chapter |
| 1 - | 20 Nm |
| 2 - | ATF-pump |
| q | disassembling and assembling → Chapter |
| 3 - | Gasket |
| q | for ATF pump |
| 4 - | Brake band -B2- |
| q | 2. 2nd and 4th gear-brake |
| q | adjust → Chapter |
| q | lay aside in fitting position → Chapter |
| q | insert the piston pressure rod → Item and adjusting screw → Item in the moulded part of the brake band |
| 5 - | 45 Nm |
| 6 - | Adjusting screw |
| q | for brake band -B2- |
| q | always replace |
| q | setting brake band → Chapter |
| 7 - | Adjusting washer |
| q | Determine thickness → Chapter, set clutch clearance between -K2- and ATF pump |
| 8 - | Reverse gear-clutch -K2- |
| q | disassembling and assembling → Chapter |
| 9 - | Axial needle bearing |
| q | check fitting position → Chapter |
| 10 - | 1st through 3rd gear clutch -K1- with turbine shaft |
| q | disassembling and assembling → Chapter |
| 11 - | Axial needle bearing |
| q | check fitting position → Chapter |
| 12 - | Drive shaft |
| 13 - | Axial needle bearing with washer |
| q | check fitting position → Chapter |
| 14 - | Sun gear, large |
| 15 - | Drive pinion |
| q | disassembling and assembling → Chapter |
| q | assigned to gearbox identification characters as a spare part |
| 16 - | Gearbox housing |
| 17 - | Circlip |
| 18 - | Cover |
| q | with 4th gear control piston |
| 19 - | Control piston 2nd and 4th gear brake |
| q | for brake band -B2- |
| q | assigned to gearbox identification characters as a spare part |
| 20 - | Spring |
| 21 - | Spring |
