Fabia Mk1
| Vehicle components |
| Gearbox components → Chapter |
| 1 - | Engine control unit |
| q | Fitting location and removing and installing → Fig. |
| q | Signal transfer occurs over the data BUS drive |
Note| If the engine or gearbox control units are replaced, the system must be put into the basic setting → Chapter |
| 2 - | Selector lever position indicator -Y6- |
| q | Fitting location → Fig. |
| q | Signal transfer occurs over the data BUS drive |
| 3 - | Diagnostic connection |
| q | Fitting location → Fig. |
| 4 - | Selector lever lock solenoid -N110- |
| q | Fitting location and removing and installing → Chapter |
| q | is switched by the vehicle voltage control unit -J519- |
| 5 - | Brake light switch -F- |
| q | Fitting location → Fig. |
| q | Signal transfer occurs via the data BUS drive of the ABS with EDL control unit -J104- |
| 6 - | Relay for starter interlock switch -J207- |
| q | Fitting location → Fig. |
| q | is switched by the vehicle voltage control unit -J519- |
| 7 - | Sender for accelerator pedal position -G79- |
| q | Fitting location and removing and installing → Fig. |
| q | generates the kick-down signal |
| q | Signal transfer occurs over the data BUS drive of the engine control unit |
| 8 - | Gearbox |
| q | Electric/electronic components of the gearbox → Chapter |
| 9 - | Automatic gearbox control unit -J217- |
| q | Fitting location → Fig. |
| q | removing → Fig. |
| q | Control unit is checked by self-diagnosis → Chapter |
