skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Installing > < Replacing the left flange shaft gasket ring

Fabia Mk1

Removing
Removing
–  Remove front wheel and raise vehicle.
–  If applicable remove the noise insulation below the engine/gearbox
–  Remove the wheelhouse liner from the left wheelhouse.
–  Turn steering to full left lock.
–  Unscrew the drive shaft from the flange shaft.
   
–  Mark installation position of bolts -1- for left steering joint, otherwise the steering geometry must be checked.
–  Release screws -1-.
–  Unbolt coupling rod -2- from the anti-roll bar -arrow-.
–  Drive shaft into the wheelhouse and secure to the suspension strut with e.g. wire.
–  Position the catch pan under the gearbox.
For gearbox after 06.00
–  Release fixing screw for flange shaft, to do so secure flange against turning.
For all gearboxes
  S39-0142
–  Remove the left flange shaft, to this end turn the adapter -MP 3-419/40- into the flange shaft and using multi-purpose tool -MP 3-419- pull out the flange shaft from the differential bevel gear large.
  Note
Push the brake hose sideways when removing the flange shaft.
  S39-0139
–  Remove the gasket ring of the flange shaft.
  S39-0143

Installing > < Replacing the left flange shaft gasket ring