skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the clutch pedal > < Summary of components - Foot controls

Fabia Mk1

Removing and installing the over-centre helper spring
Removing and installing the over-centre helper spring
Special tools and workshop equipment required
t  Pliers -T10005-
Removing
–  Remove the storage area on the driver's side → Body Work; Rep. Gr.70.
–  Remove clutch pedal switch, if provided → Item.
   
Unlock the actuating rod/master cylinder from the clutch pedal as follows:
–  Insert pliers -T10005- in the clutch pedal recesses.
–  Press together support and separate the clutch pedal from the master cylinder.
  S30-0051
–  Push the over-centre helper spring against the partition panel -in the direction of the arrow- and remove from the bracket from the bottom.
Install
  S30-0064
–  Insert bearing for over-centre helper spring -arrow 1- in the bracket holder.
The peg of the bearing is located in the recess of the master cylinder -arrow 2-.
–  Insert over-centre helper spring in the bearing.
  S30-0068
–  Press over-centre helper spring against the bearing and position on the support of the clutch pedal -arrow-.
–  Position the clutch pedal with the master cylinder → Chapter.
–  Installing the clutch pedal switch → Item.
–  Install the storage area on the driver's side → Body Work; Rep. Gr.70.
  S30-0065

Removing and installing the clutch pedal > < Summary of components - Foot controls