Fabia Mk1
I - Disassembling and assembling gearbox housing cover and 5th gear |
1 - | 14 Nm |
2 - | Cover for gearbox housing |
Note
If the gearbox housing cover is fitted with the gearbox mounted, inspect the gear oil level, if necessary top up with oil → Chapter. |
3 - | Gasket |
4 - | Inside Torx screw M10, 80 Nm |
q | holds disc spring in position with sleeve socket on screw head |
q | always replace → Electronic Catalogue of Original Parts |
5 - | Disc spring |
q | installing → Chapter |
6 - | 25 Nm |
q | for bearing pins on the gearbox housing |
7 - | Bearing pins |
8 - | 5th gear shift fork |
q | disassembling and assembling → Chapter |
q | adjust → Chapter |
9 - | Spring |
q | on gearboxes as of manufacturing date 10.04 the spring was changed → Chapter |
10 - | 5th gear sliding sleeve |
11 - | Arresters (3 pieces) |
q | on gearboxes as of manufacturing date 03.01 are installed the arresters, which are hollow inside |
12 - | Synchronizer body with sliding gear and synchronizer ring for 5th gear |
q | disassembling and assembling → Chapter |
q | remove → Anchor, |
13 - | Needle bearing |
14 - | Gear pinion for 5th gear |
q | Fitting position → Chapter |