–
| Insert counterholder -MP1-223 (3067)- to slacken and tighten the bolts. |
–
| Release bolts in small stages crosswise. |
–
| Remove pressure plate and clutch disc. |
–
| Fit the pressure plate onto the centering pins of the flywheel. |
Note The thrust surface of the pressure plate and the clutch disc lining must fully rest against the flywheel before the screws are inserted. |
–
| Screw in all the screws by hand uniformly, until the bolt head rests against the pressure plate. |
–
| Tighten the screws in small stages crosswise (tightening torque → Chapter), so as not to damage the centering holes on the pressure plate and the centering pins of the flywheel. |
|
|
|