Fabia Mk1
| Control cables as of 06.06 |
Note| Grease bearing and friction surfaces with grease -G 000 450 02-. |
| 1 - | Shift cable |
| q | lever off from the shift lever guide within the shift mechanism |
| q | press onto the shift lever guide within the shift mechanism |
| q | connect with cable lock Pos. 11 |
| q | Fitting position → Chapter |
| 2 - | Selector cable |
| q | lever off from the selector angle plate within the shift mechanism |
| q | press onto the selector angle plate within the shift mechanism |
| q | connect with cable lock Pos. 10 |
| q | Fitting position → Chapter |
| 3 - | Bush |
| q | for selector cable |
| 4 - | Lock washer |
| q | do not damage cables when removing |
| q | replace → Electronic Catalogue of Original Parts |
| 5 - | Shift housing |
| 6 - | Cable support |
| q | out of plastic or metal |
| 7 - | Grommet |
| q | for mounting of cable support to gearbox |
| 8 - | Spacer |
| 9 - | 23 Nm |
| q | 3 pieces |
| q | for cable support |
| 10 - | Cable lock |
| q | for selector cable Pos.2 at relay lever Pos.14 |
| q | Assignment → Fig. |
| q | is secured with the lock washer Pos.18 for metal relay lever |
| q | installed as of 06.06 in combination with plastic relay lever → Chapter |
| q | remove from plastic relay lever and press onto plastic relay lever → Chapter |
| q | after installing set shift mechanism → Chapter |
| 11 - | Cable lock |
| q | for shift cable |
| q | Assignment → Fig. |
| q | is secured with lock washer Pos. 18 |
| q | after installing set shift mechanism → Chapter |
| 12 - | Lock washer |
| q | replace → Electronic Catalogue of Original Parts |
| q | is not required for plastic relay lever |
| 13 - | Bushing |
| q | is not required for plastic relay lever |
| 14 - | Reversing lever |
| q | Fitting position → Fig. |
| q | after installing set shift mechanism → Chapter |
| q | made out of plastic or metal |
| q | Metal relay lever is located in the bushings Pos. 13 and secured with a lock washer Pos. 18 |
| q | as of 06.06 plastic relay lever |
| q | remove and install plastic relay lever together with cable lock Pos. 10 → Chapter |
| q | Bushings pos. 13 and lock washer pos. 18 are not required for plastic relay lever |
| 15 - | Sliding shoe |
| 16 - | Gearshift lever |
| q | with balancing weight |
| q | insert in such a way that the interrupted spacing of the teeth matches the gearshift shaft → Fig. |
| q | after installing set shift mechanism → Chapter |
| q | Fitting position → Fig. |
| 17 - | 20 Nm |
| q | replace → Electronic Catalogue of Original Parts |
| 18 - | Lock washer |
| q | replace → Electronic Catalogue of Original Parts |
| q | is not required for plastic relay lever |
|
|
| Cable lock for: | Dimension “a” |
| Shift cable at gearbox shift lever | 10 mm |
| Selector cable at relay lever | 8 mm |
