Fabia Mk1
Note
|
1 - | Clutch housing |
2 - | Cylindrical-roller bearing |
q | with circlip |
q | removing → Fig. |
q | pressing on → Fig. |
q | Fitting position: the circlip in the bearing points towards the output shaft |
3 - | Output shaft |
q | if an inner ring is fitted as a bearing assembly for the cylindrical-roller bearing Pos. 2, it cannot be removed from the output shaft |
q | Inspect bearing assembly or inner ring for cylindrical-roller bearing for scoring and damage |
q | replace output shaft and cylindrical-roller bearing together if there is scoring and damage on the bearing assembly or inner ring |
4 - | 4th gear pinion |
q | Fitting position: Collar points to the 3rd gear → Fig. |
5 - | Circlip |
6 - | Circlip |
7 - | 3rd gear pinion |
q | Fitting position: Collar points to the 4th gear → Fig. |
8 - | Circlip |
9 - | 2nd gear sliding gear |
10 - | Needle bearing |
q | for 2nd gear |
11 - | Inner ring for 2nd gear |
q | check for wear → Fig. |
q | Fitting position → Fig. |
12 - | Outer ring for 2nd gear |
q | place onto the inner ring Pos. 11 |
q | replace if there are any traces of scoring or of friction |
q | Fitting position → Fig. |
13 - | 2nd gear synchronizer ring |
q | check for wear → Fig. |
q | Fitting position → Fig. |
14 - | Sliding sleeve with 1st and 2nd gear synchronizer body |
q | press off together with 2nd gear sliding gear → Fig. |
q | disassembling → Fig. |
q | Assembling the sliding sleeve with synchronizer body → Fig. and → Fig. |
q | Fitting position → Fig. and → Fig. |
q | pressing on → Fig. |
15 - | Circlip |
q | pushing out → Fig. |
q | inserting → Fig. |
16 - | 1st gear synchronizer ring |
q | check for wear → Fig. |
q | insert in such a way that the recesses lock into the arresters on the sliding sleeve Pos. 14 |
17 - | Outer ring for 1st gear |
q | fit into synchronizer ring -Pos. 16-, fitting position → Fig. |
q | replace if there are any traces of scoring or of friction |
18 - | Inner ring for 1st gear |
q | check for wear → Fig. |
q | check pegs for wear |
q | Fitting position → Fig. |
19 - | Needle bearing |
q | for 1st gear |
20 - | 1st gear sliding gear |
q | Fitting position → Fig. |
21 - | Bearing support for grooved ball bearing |
q | Always replace grooved ball bearing together with the bearing support |
q | replace after each removal |
q | removing and installing → Chapter |
22 - | Gearbox housing |
23 - | 5th gear pinion |
q | Fitting position: Collar points towards the cover of the gearbox housing → Chapter |
24 - | Circlip |
q | always replace → Electronic Catalogue of Original Parts |
q | Determine thickness → Chapter |
25 - | Spring |
q | Fitting position → Fig. |
26 - | Sliding sleeve |
27 - | Synchronizer body |
28 - | Arresters for synchronizer body |
q | (3 pieces) |
|
|
|
|
|
Fitting dimension | Wear limit | |
Clearance -a- | 0.75…1.25 mm | 0.3 mm |
|
Fitting dimension | Wear limit | |
Clearance -a- | 1.2…1.8 mm | 0.5 mm |
|
|
|
|
|
|
|
|