Fabia Mk1
Foot Controls, Master cylinder - Summary of Components |
Note
t | Grease all bearing and contact surfaces with Polycarbamide Grease -G 052 142 A2-. |
t | Prior to working on the foot controls remove the bottom part of the dash panel → Body Work; Rep. Gr.70. |
t | Hydraulics - Summary of components → Chapter. |
1 - | Support/Front wall |
q | for master cylinder and bracket |
2 - | Gasket |
q | replace → Electronic Catalogue of Original Parts |
3 - | Bracket |
q | for support of clutch pedal |
q | removing and installing → Chapter |
4 - | Screw |
5 - | Gas/brake foot controls |
6 - | 25 Nm |
q | self-locking |
q | replace → Electronic Catalogue of Original Parts |
7 - | Clutch pedal switch -F36- |
q | Difference → Chapter |
q | Removing and installing clutch pedal switch with angular housing → Chapter |
q | Removing and installing clutch pedal switch with round housing → Chapter |
8 - | Over-centre helper spring |
q | removing and installing → Chapter |
9 - | Spacer bush |
10 - | Bushing |
11 - | Clutch pedal |
q | removing and installing → Chapter |
12 - | Support |
q | removing and installing → Chapter |
13 - | 25 Nm |
q | self-locking |
q | replace → Electronic Catalogue of Original Parts |
14 - | Master cylinder |
q | removing and installing → Chapter |
15 - | Retaining clip |
q | to remove and install the tube-hose line pull out retaining clip up to the stop |
16 - | Tubing |
q | out of rubber |
q | as of 12.05 on certain vehicles out of plastic → Fig. |
17 - | Bearing |
q | for over-centre helper spring |
q | insert in bracket |
q | Fitting position: the peg -arrow- locks into the master cylinder recess |
q | to replace, remove and install the master cylinder → Chapter |
18 - | Screw |
q | for pedal stop on bracket |
19 - | Pedal stop |
q | screw onto bracket with screw (-Pos. 18-) with the master cylinder installed |
20 - | 25 Nm |
q | self-locking |
q | replace → Electronic Catalogue of Original Parts |