skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Mounting sequence > < Removing and installing gearbox housing and shift mechanism - Summary of components
Removing and installing the drive shaft, output shafts (input shafts), differential and gear shift rods - Summary of components
   
Removing and installing the drive shaft, output shafts (input shafts), differential and gear shift rods - Summary of components
1 - Output shaft gears 1 through 4
q   disassembling and assembling → Chapter
q   Fitting position → Fig.
2 - Gear shift rod with shift fork for 1st and 2nd gear
q   Fitting position → Fig.
3 - Gear shift rod with shift fork for 3rd and 4th gear
q   Fitting position → Fig.
4 - Output shaft 5th/6th and reverse gear
q   disassembling and assembling → Chapter
q   Fitting position → Fig.
5 - Gear shift rod with shift fork for 5th and 6th gear
q   Fitting position → Fig.
6 - Gearshift fork reverse gear
q   Fitting position → Fig.
7 - Drive shaft
q   disassembling and assembling → Chapter
8 - Reverse shaft
q   with thrust washer
9 - Thrust washer
10 - Breather
q   connect with slave cylinder (-Pos 16-)
11 - 12 Nm
q   self-locking
q   always replace → Electronic Catalogue of Original Parts
12 - Lock washer
q   secures the outer ring/tapered-roller bearing for drive shaft
13 - Clutch housing
q   repairing → Chapter
14 - Gasket ring for drive shaft
15 - O-ring
q   always replace → Electronic Catalogue of Original Parts
q   pull onto line connection
q   moisten with brake fluid before installing
16 - Slave cylinder with release bearing
17 - Screw
q   for metal slave cylinder: 12 Nm
q   for plastic slave cylinder: 15 Nm
q   3 pieces
q   always replace → Electronic Catalogue of Original Parts
q   carefully tighten in small stages crosswise so that the screw-down eyes of the slave cylinder do not break off
18 - Conical screw, 25 Nm
19 - Right flange shaft with pressure spring
q   removing and installing → Chapter
q   complete → Chapter
20 - O-ring
q   always replace → Electronic Catalogue of Original Parts
21 - Sender for speedometer
22 - 12 Nm
q   always replace → Electronic Catalogue of Original Parts
23 - Differential
q   disassembling and assembling → Chapter

   
Fitting position of the drive shaft and the output shafts (input shafts) in the gearbox
1 - Output shaft 5th/6th and reverse gear
2 - Drive shaft
3 - Output shaft gears 1 through 4
4 - Differential
  N34-1036
Fitting location of complete shift mechanism in the gearbox:
1 - 3rd and 4th gear shift fork
2 - 1st and 2nd gear shift fork
3 - Gearshift fork reverse gear
4 - 5th and 6th gear shift fork
5 - Gearshift shaft
The bottom bearing of the gearshift shaft -Pfeil- is screwed with the cap to the gearbox housing.
  N34-0993

Mounting sequence > < Removing and installing gearbox housing and shift mechanism - Summary of components