Regulations concerning cleanliness when working on the fuel supply/fuel injection system |
Carefully observe the following „6 rules“ for cleanliness when working on the fuel supply/injection system: |
t
| Thoroughly clean the connection points and their surroundings before releasing. |
t
| Place removed parts on a clean surface and cover. Do not use fuzzy cloths! |
t
| Carefully cover or seal opened or removed components if the repair is not carried out immediately. |
t
| Only install clean parts: Remove spare parts from their wrapping immediately before installing. Do not use any parts which have been stored unwrapped (e.g. on a shelf or in a tool box etc...). |
t
| When the system is opened: Avoid using compressed air. Avoid moving the vehicle. |
t
| Also make sure no diesel fuel runs onto the coolant hoses. If this is the case clean the hoses immediately. Replace immediately any hoses which have suffered damage. |
|
|
|