Fabia Mk1
| Cylinder head - summary of components |
| 1 - | Screw cap |
| 2 - | Gasket |
| q | replace if damaged |
| 3 - | 10 Nm |
| q | Tighten nuts crosswise |
| 4 - | Bleeder hose |
| 5 - | Gasket |
| q | replace |
| 6 - | Plugs, 15 Nm |
| 7 - | Cylinder head bolt |
| q | replace |
| q | sequence for slackening and tightening → Chapter |
| 8 - | Connection fittings |
| q | for cylinder head |
| 9 - | 10 Nm |
| 10 - | Sealing ring |
| q | replace |
| 11 - | 20 Nm |
| 12 - | Lifting eye |
| 13 - | Cylinder head gasket |
| q | replace |
| 14 - | 15 Nm |
| 15 - | 20 Nm |
| 16 - | Rear toothed belt guard |
| 17 - | Toothed belt |
| q | before removing mark running direction |
| q | check for wear |
| q | do not kink |
| q | removing and installing, tensioning → Chapter |
| 18 - | Cylinder head |
| q | removing and installing → Chapter |
| q | check for distortion → Chapter |
| q | reworking sealing surface → Chapter |
| q | after replacing fill entire system with fresh coolant → Chapter |
| 19 - | Oil separator |
| 20 - | Gasket for cylinder head cover |
| q | replace if damaged or leaking |
| q | before fitting, coat sealing surfaces of bearing cap and cylinder head cover with -D 454 300 A2- |
| 21 - | Cylinder head cover |
