skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

The dash panel insert - a rear view > < Dash panel insert
Removing and installing the dash panel insert
Removing and installing the dash panel insert
  WARNING
Disconnect earth strap from the battery with the ignition off before commencing work on the electrical system.
  Note
t  Before disconnecting the battery determine the code of radio sets fitted with anti-theft coding.
t  Observe the instructions after reattaching the battery → Chapter
Removing
  Note
It is not necessary to remove the steering wheel. For reasons of clarity the steering wheel is not shown in the following illustrations.
–  Pull steering wheel out fully and lock it in its lowest position.
   
–  Unclip the cover -1- and put it to one side.
–  Screw out both screws -2- (1.4 Nm).
–  Pull the dash panel insert -3- out slightly and disconnect the two plug connections.
–  Take out the dash panel insert.
Install
–  Installation is carried out in the reverse order.
If the dash panel insert has been replaced because of a fault, it is then necessary to carry out the following procedures:
–  Check coding of the dash panel insert or code dash panel insert.
  Note
For vehicles with dash panel insert 6Y0 920 xxx x, the dash panel insert must be coded or adapted with Vehicle Diagnosis, Measurement and Information System -VAS 5051-.
–  Adapt odometer reading.
–  Adapt service interval display.
–  Adapt immobiliser.
  S90-0045

The dash panel insert - a rear view > < Dash panel insert