skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Self-diagnosis functions > < Initiating self-diagnosis
Connecting vehicle system testerV.A.G 1552
Connecting vehicle system tester -V.A.G 1552-
The diagnostic connection is located on the left next to the storage compartment on the driver's side.
–  Unclip cover and remove downward.
   
–  Connect vehicle system tester -V.A.G 1552- with appropriate cable.
–  Switch on ignition.
  S01-0087
Readout on display:
  Note
If there is nothing on the display → Operating instructions for the vehicle system tester.
–  Enter address word 19“Gateway data bus” and confirm the entry with Q.
 
Vehicle system test                 HELP
Enter address word XX
After approx. 5 s the display will show e.g.:
t  6N0909901: Number of the Gateway
t  Gateway K [lt ]-> CAN: Designation of component
t  1522: Software version of the Gateway
t  Coding 00014: Coding of the Gateway
t  WSC xxxxx: Workshop code
  Note
Check coding with the table of codes.
–  Press .
 
6N0909901  Gateway  K [lt    ]-> CAN      1522
Coding 00014                    WSC xxxxx
If one of the following messages appears in the display, carry out fault finding as stated in the fault finding programme diagnostic cable → Current flow diagrams and Fitting locations.
 
Vehicle system test                 HELP
The control unit does not respond!
 
Vehicle system test                 HELP
Fault in communication set-up
 
Vehicle system test                 HELP
K cable does not connect to earth
–  Move forward in the test program by pressing .
 
Vehicle system test                 HELP
K cable does not connect to pos. term.

Self-diagnosis functions > < Initiating self-diagnosis