skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the cruise control (CC) > < Removing and installing the V-ribbed belt pulley on the AC generator

Fabia Mk1

Removing and installing the V-ribbed belt pulley with free wheel
Removing and installing the V-ribbed belt pulley with free wheel
Special tools and workshop equipment required
t  Torque wrench
t  Polygon-head adapter -MP 1-309- ( -3400- )
–  Removing the installed V-ribbed belt pulley → Chapter.
–  Insert the polygon-head adapter -MP 1-309- ( -3400- ) in the free wheel pulley.
–  Screw freewheel belt pulley first of all by hand onto drive shaft of alternator as far as the stop.
To mount the free wheel pulley adapt the torque spanner as follows:
–  Release socket insert for removing and installing ribbed V-belt pulley and pull it off the handle part.
–  Turn handle part of part of torque wrench 180 degrees and re-insert socket insert.
–  Position direction of rotation of torque wrench to left.
–  Adjust a tightening torque of 80 Nm on the torque wrench.
–  Position the hexagon socket, SW 6 mm on the drive shaft of the AC generator.
   
–  Hold the polygon-head adapter -MP 1-309- with ring spanner, SW 17, and tighten the free wheel pulley to 80 Nm by turning the drive shaft to the left using a torque wrench.
–  Clip the protective cap onto the free wheel pulley.
  S27-0070

Removing and installing the cruise control (CC) > < Removing and installing the V-ribbed belt pulley on the AC generator