Repairing corrugated washer fluid level pipes - vehicles as of 01.2011 |
Note t
| The following repair procedure of corrugated washer fluid level pipes can also be applied to vehicles manufactured up to 01.2011. |
t
| The repair point must not be exposed to tension or flexion. |
t
| If the damaged point is longer than 15 mm, insert new corrugated pipe and then perform the described work sequence twice. |
Special tools and workshop equipment required |
–
| Cut the damaged point straight out of the corrugated pipe to be repaired so that the distance between the pipe ends is maximum 15 mm. |
|
|
|