Fabia Mk2
| Removing and installing the partition panel of the plenum chamber lock carrier |
| 1 - | Plenum chamber cover |
| Removing: |
| – | Remove front windscreen wipers → Electrical System → Rep. gr.92. |
| – | Pull out the engine bonnet seal (Pos. 6). |
| – | Remove plastic nuts (Pos. 2). |
| – | Detach water pipe to the washer nozzles (including angular piece). |
| – | Disconnect the plug connections of the heated washer nozzles (depending upon vehicle equipment). |
| – | Remove plenum chamber cover (Pos. 1). |
| Installing: |
| – | Installation is carried out in the reverse order. |
| 2 - | Nut (2 Nm) |
| 3 - | Air inlet cover |
| 4 - | 9 Nm |
| 5 - | Partition panel |
| Removing: |
| – | Remove plenum chamber cover (Pos. 1). |
| – | Remove damping for partition panel (Pos. 8). |
| – | Remove plastic nut (Pos. 10). |
| – | Remove screws (Pos. 4). |
| – | Carefully remove the partition panel from the engine compartment. |
| Installing: |
| – | Installation is carried out in the reverse order. |
| 6 - | Engine bonnet seal |
| 7 - | Plastic nut |
| 8 - | Damping for partition panel |
| Removing: |
| – | Remove engine control unit (with bracket) → Engine → Rep. gr.23 (on petrol engines Rep. Gr. 24). |
| – | Remove bracket for plug of electrical cable (depending upon vehicle equipment and engine type). |
| – | Remove metal lock washers (Pos. 9). |
| – | Remove plastic nut (Pos. 7). |
| – | Pull out the engine bonnet seal (Pos. 6). |
| – | Remove the damping from the engine compartment. |
| Installing: |
| – | Installation is carried out in the reverse order. |
| 9 - | Metal lock washer |
| 10 - | Nut (2 Nm) |
