skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Removing and installing outer door handle > < Removing and installing window lifter motor
Removing and installing the door lock
Removing and installing the door lock
Removing:
–  Switch off the ignition and all electrical components (on vehicles with central locking system).
–  Remove rear door trim panel → Chapter.
–  Remove the protective foil for rear door.
–  Removing the door handle → Chapter.
–  Remove fixing screws for door lock → Chapter.
–  Disconnect the plug connection (on vehicles with central locking system).
–  Take out door lock.
–  Unhook the control cable of the mechanical door lock (depending upon vehicle equipment).
   
–  If necessary unhook control cable -1-.
Installing:
–  Installation is carried out in the reverse order.
  Note
Perform a functional check because the door cannot be opened if the adjustment is not accurate and the Bowden wire is not clipped on correctly.
  S57-0142

Removing and installing outer door handle > < Removing and installing window lifter motor