Fabia Mk2
|
WARNING
| 1 - | Headrest guides |
| q | Removing: |
| – | Press safety catch -arrow-, e.g. with a specially adapted screwdriver and remove the guides. |
| q | Installing: |
| – | Clip guide downwards into the backrest rack. |
| 2 - | Backrest rack |
| 3 - | Longitudinal wire of the backrest rack |
| 4 - | Transverse wire of the backrest rack |
| 5 - | Airbag unit (depending upon vehicle equipment) |
| q | Removing and installing → Chapter. |
| 6 - | El. wire of the airbag unit |
| 7 - | Terminal el. wire airbag |
| 8 - | Foam padding wire of backrest rack |
| 9 - | Retaining clips |
| q | When removing cut through with pliers |
| q | To install use upholstery pliers, e.g. -V.A.G 1634-, -V.A.G 1634-. |
| 10 - | El. wire of heating element (depending upon vehicle equipment) |
| 11 - | Heating element (depending upon vehicle equipment) |
| 12 - | Cover |
| q | Removing: |
| – | Remove headrests. |
| – | Remove the backrest rack from the seat rack → Chapter. |
| – | Remove headrest guides (Pos. 1). |
| – | Fully unhook clamping (Pos. 14) at the bottom cover side. |
| – | Remove cover up to approx. 1/4. |
| – | Remove dummy plugs from the holes in the bottom section of the backrest and unhook the longitudinal wires of the backrest rack (Pos. 3). |
| – | Cut through the retaining clips (Pos. 9). |
| – | Draw the heating cable (Pos. 10) through the cover. |
| – | Unhook tensioning elastics. |
| – | Roll up cover. |
| – | Cut through the second row of retaining clips (Pos. 9). |
| – | Unhook the transverse wire of the backrest rack (Pos. 4) on the rear side of the backrest. |
| – | Section the longitudinal wire retaining clips of the backrest (Pos. 3). |
| – | Unhook the longitudinal wire on the rear side of the backrest and pull through to the front. |
| – | Roll up cover and section the longitudinal wire retaining clips. |
| – | Remove cover from backrest. |
| q | Installation is carried out in the reverse order. |
Note| Make sure that the cover is correctly taken out. |
| 13 - | Plastic cord |
| q | Sewn with cover -12-. |
| q | With holes for inserting retaining clips -9-. |
| 14 - | Clamping section of cover |
| q | Sewn to cover |
| 15 - | Foam padding |
| q | Removing: |
| – | Remove cover (Pos. 12). |
| – | Remove foam padding from backrest rack. |
| q | Installation is carried out in the reverse order. |
