skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Assembling the AAR 2000 tripod joint > < Repairing the drive shaft with AAR 2000 tripod joint

Fabia Mk2

Disassembling the AAR 2000 tripod joint
Disassembling the AAR 2000 tripod joint
–  Removing drive shaft → Chapter.
   
–  Open hose clamp on joint part.
  S40-0329
–  Straighten the metal tabs -arrows- with a screwdriver and lever off cover.
  S40-0145
–  Remove O-ring seal -arrow- from the slot.
–  Mark the fitting position of parts -1...3-.
1 - Joint part
2 - Tripod spider
3 - Drive shaft
  Note
t  If parts -1...3- are not marked and if they are not fitted in their original position again this could cause noises during driving at a later stage.
t  Use a waterproof marker for marking.
  S40-0330
–  Clamp the drive shaft in a vice with the protective jaws.
–  Take off circlip.
1 - Circlip pliers (commercially available)
–  Hold the joint part and remove drive shaft from the vice.
–  Insert the drive shaft in the press.
  S40-0148
–  Hold the drive shaft and push tripod spider off the drive shaft.
–  Remove the tripod spider with rollers and lay aside on a clean surface.
–  Remove the joint part from the drive shaft.
–  Remove the joint boot from the drive shaft.
–  Clean the drive shaft and the joint part.
  S40-0144

Assembling the AAR 2000 tripod joint > < Repairing the drive shaft with AAR 2000 tripod joint