–
| Insert the spindle -MP5-401/2- with washer -1- and pressure plate -T40023- from the rear into the rubber-metal bearing. |
–
| Screw the spindle -MP5-401/2- into the thread of the console -arrow-, until the pressure plate -T40023- is resting against the rubber-metal bearing. |
–
| Pulling out the rubber-metal bearing. |
Inserting the rubber-metal bearing: |
Note t
| Use assembly sliding oil -G 294 421 A1- to insert. |
t
| This leaves a slightly sticky film, which ensures a tight fit of the bearing. |
t
| Commercially available greases/oils are usually acidic and leave behind a grease film, which could result in a corrosion of the rubber-metal bearing or during compression and rebound of the vehicle the whole rubber-metal bearing may turn in the track control arm and not the actual rubber in itself. |
|
|
|