Fabia Mk2
| Summary of components of the lubrication system (Superb II, Octavia II, Fabia II, Roomster) |
Note| t | If considerable quantities of metal swarf or abrasion is found in the engine oil when carrying out engine repairs, carefully clean the oil galleries and additionally replace the oil cooler. |
| t | The oil level must not exceed max. marking. - Risk of damage to catalytic converter! |
| Check engine oil level, oil capacity and oil specification → Superb II, → Octavia II, → Fabia II, → Roomster. |
| 1 - | 15 Nm |
| 2 - | 15 Nm |
| 3 - | Support |
| q | for cable of oil level and oil temperature sender -G266 - |
| q | pay attention to different version |
| 4 - | Sprocket |
| 5 - | Dipstick |
| q | oil level must not exceed max. marking |
| 6 - | Filler funnel |
| q | Remove for extracting oil |
| 7 - | Guide tube |
| 8 - | Oil injection nozzle |
| q | for piston cooling |
| q | Pay attention to part number (right-angle bend) |
| 9 - | Pressure valve, 27 Nm |
| q | opens at a pressure of 0.25 to 0.32 MPa |
| q | replace without sealant |
| 10 - | O-ring |
| q | replace |
| 11 - | Suction line |
| q | Clean strainer if dirty |
| 12 - | Baffle |
| 13 - | Oil pan |
| q | remove and install Superb II → Chapter, Octavia II → Chapter, Fabia II → Chapter, Roomster → Chapter |
| q | install with silicone sealant -D 176 600 A1- |
| 14 - | Oil drain plug, 30 Nm |
| q | with gasket |
| q | replace |
| 15 - | 10 Nm |
| q | replace |
| 16 - | Oil level and oil temperature sender -G266- |
| q | check → Vehicle diagnosis, testing and information system VAS 5051 |
| 17 - | O-ring |
| q | replace |
| 18 - | Oil pump |
| q | with pressure relief valve 1.2 MPa (12 bar) |
| q | removing and installing → Chapter |
| q | Before installing, check whether both dowel sleeves for centering oil pump/cylinder block are present |
| q | if there is any scoring on the contact surfaces of the gears, replace |
| q | Tighening torque of oil pump cover at oil pump housing: 10 Nm |
| 19 - | Oil pump sprocket |
| q | Fits onto oil pump shaft in one position only |
| 20 - | Bracket at bottom |
| q | for the cable to the oil level and oil temperature sender |
| 21 - | 15 Nm |
| 22 - | 20 Nm + torque a further 90° (1/4 turn) |
| q | replace |
| 23 - | Oil pump chain |
| q | before removing mark running direction |
| q | check for wear |
| 24 - | Sealing flange on the belt pulley side |
| q | Replace gasket ring for crankshaft on belt pulley side Superb II → Chapter, Octavia II → Chapter, Fabia II → Chapter, Roomster → Chapter |
| q | remove and install Superb II → Chapter, Octavia II → Chapter, Fabia II → Chapter, Roomster → Chapter |
| 25 - | Chain tensioner |
| q | do not disassemble |
| q | Replace chain tensioner if spring is broken. |
| q | Check fitting position |
| q | When installing, hook on the spring and pretension |
| q | tighten to 16 Nm |
